Frekote 710 LV is a clear colorless liquid, solvent based polymer mold release chemical. This advanced material has a high gloss finish, high slip and is capable of a non-contaminating transfer. It is specifically formulated for high composite materials. The solvent based polymer has an application temperature between 13 to 41 degrees Celsius.
Loctite Frekote 710 is a reduced VOC, semi-permanent, mold release chemical. This product is capable of releasing a wide variety of material, some including polyester resins, thermoplastic compounds, and epoxies. It is high slip and provides no mold build-up. It is strongly recommended to clean and dry surfaces before using Frekote 710 LV. Apply the material with a clean, lint free cotton cloth. Wet the cloth with material until it is damp but not dripping. For the best results, it is suggested to apply a minimum of two coats allowing 5 to 10 minutes after each application to allow complete solvent evaporation. Film will be dry and not feel tacky. The cure time for the final coat should be approximately 15 to 20 minutes at a temperature of 25 degrees Celsius. This system is capable of being applied at room temperature and cured at ambient shop temperatures in 30 minutes. Re-coating the substrates after the initial cure has finished will enhance the performance. Unused molds that have been previously cured need to be sealed before use.
It is important not to use Frekote 710 LV in pure oxygen systems and it should not be selected as a sealant for chlorine or other strong oxidizing materials. This product is flammable so it needs to be stored in a safe location away from combustible materials and oxidizing agents. The ideal storage temperature of Frekote 710 LV is 8 to 21 degrees Celsius. Anything above or below those temperatures can change the properties of the product adversely. Once the material is removed from the container, it is strongly recommended not to return it back because it may have become contaminated during use. The cured thermal stability of this high quality product is less than or equal to 400 degrees Celsius. If more information is required about this release agent, refer to the Frekote 710 LV MSDS.
Henkel manufactures some of the highest performing mold release agents that have set industry standards and met the demands of customer worldwide. Frekote 710 LV is a state-of-the-art product produced with the highest quality of materials. Frekote 710 LV is a solvent based polymer with high slip, high gloss finish, reduced VOCs, no mold build-up and non-contaminating transfer. Krayden Inc., a certified distributor of Henkel products can assist in providing world-class customer service and technical support in finding materials and information regarding them. For more information go to the Frekote 710 LV TDS.